Putty

#805/#806 PREMIUM POLYESTER FINISHING PUTTY

PRODUCT DESCRIPTION:
ADVANTAGE Premium Polyester Finishing Putty is effortless to spread and self-levels to a smooth, easy-to-sand surface that is pinhole free – improving your cycle time. The advanced easy-powder formula increases the sanding window. #805 provides excellent results for that invisible repair every time whether over body filler, sand scratches, pinholes, aged OEM topcoats, steel, aluminum, galvanized and other zinc-coated metals, fiberglass and a wide variety of other substrates.

PRODUCT USES:
Use for minor body work and surface imperfections (1/8" thick or less) such as sand scratches, chips, scratches and pinholes. Ideal for use as a finish coat over body filler.

TYPICAL SUBSTRATES:
• Steel
• Aluminum
• Fiberglass
• Body Filler
• Wood
• 2K Primers
• Aged, sanded OEM Topcoats
• Galvanized and other zinc-coated steel
• SMC – can be used for cosmetic repairs. For structural repairs prone to high degrees of stress and flexibility, use an SMC repair product.

SURFACE PREPARATION:
1. Clean surface. Remove all dirt, oil, grease and wax with a cleaning solvent like Wax & Grease Remover.
2. Make sure surface is dry before repairing.
3. Use 40-80 grit disc to featheredge paint for good mechanical adhesion.

MIXING DIRECTIONS:
For best results, bring filler and provided hardener to room temperature (minimum temperature 75°F). Stir product before dispensing with a bottom to top motion. Knead hardener tube before use. Place a 4" diameter puddle of filler on a clean mixing surface (we recommend a non-absorbent plastic mixing board) and add a ribbon of cream hardener from edge to edge across the center of the filler puddle (puddles larger than 4" will require additional hardener); or measure hardener at 2% by weight of filler – a 50 to 1 ratio. Mix thoroughly with a plastic spreader, using a folding motion, until uniform color is achieved. At room temperature (75°F) approximate setting time is 3 – 5 minutes.

APPLICATION DIRECTIONS:
1. Using a plastic spreader, apply a thin layer of putty to surface, using firm pressure for maximum adhesion.
2. Apply additional layers, building up damaged area higher than the surrounding surface to allow for sanding of the putty. Do not apply over fresh or uncured coatings.

FINISHING:
When material has hardened, in approximately 15 minutes, sand with 100 - 180 grit sandpaper followed by 220 - 400 grit if desired.

TOPCOATING:
May be topcoated with polyester, 2K urethane or 1K primer. Refer to paint manufacturer’s instructions for topcoat application.

HEALTH & SAFETY:
Read all warnings, first aid and safety for all components before using. Keep out of reach of children and animals. Protect hands with impervious rubber gloves. Wear face, skin and eye protection. When sanding, we recommend the use of a respiratory covering device to protect from dust (MSA mask P/N 459029 with MSA cartridge 464029 or equivalent). When using power equipment, refer to power tool manufacturer’s recommendations for safety equipment. ADVANTAGE products are for industrial use by trained professionals only.

Emergency Medical or Spill Control Information:
In U.S. and Canada call CHEMTREC at 1-800-424-9300

Call 1-87REFINISH (1-877-334-6474) to
find your local Advantage Refinish Products
supplier. Or visit our website:
www.autobodybrands.com